By utilizing high pressure hose and connector assembly and buckling mode selection is improper

By utilizing high pressure hose and connector assembly and buckling mode selection is improper. Or joint structure, material, size selection is not reasonable, can lead to joint and hose pressure too tight or too loose, causing joint early damage. The assembly, if the withholding amount is too small, crimping connector and hose pressure hydraulic flangestoo loose, under the action of oil pressure hose disengages from the joint may at the initial stage of use; if the withholding amount is too large, then the buckling pressing joint and hose pressure too tight, easily lead to hose inner layer by local damage, deformation, produce crack, high pressure oil from weak, rupture directly into the wire layer, then along the rear of the jet slot channeling to coat steel wires, or has been along the wire layer channeling somewhere accumulates, the outer layer of the hydraulic tube fitting drum kits and even cracking. Hose and connector in the assembly, if press speed too fast, easy to cause damage and fracture of the glue in the wire layer, so that the hose damage early in use. In addition, the joint design is not reasonable, Jerry, the processing quality is bad, can also cause the glue in the joint damage; if the improper material selection, not up to the high pressure hose assembly requirements. Will shorten the service life of the high pressure hose.