use of the high-pressure hose size

When the high-pressure hose be withheld , will always produce withhold too tight or too loose phenomenon, and these phenomena often lead to adverse effects of high pressure hose . Today we say it is the size of the amount withheld would it have any effect on the high-pressure hose . We carried out by the following detailed understanding .Withhold the amount and rate of withholding high pressure hose and fittings assembly when the improper or joint structure and material , size selection is unreasonable, can lead to high pressure hose and fittings withholding too hydraulic hose assemblysor too loose will cause early damage to the joints .When assembled , if the withholding amount is too small, that is between the high pressure hose connector and cut through the loose , high pressure hose there may emerge in the role of oil in the early use from the joint ; If withholding is too large, then the connector and hose too hydraulic tube fitting , easily lead to hose inner being localized damage, cracks , directly into the high-pressure oil from the ruptured steel layer , and then he went to the wire along the gap between the spray coat tails , or has fled somewhere along the wire layer build up , so that the outer layer of plastic to produce drum kits and even rupture . Hoses and connectors in the assembly, if the withholding too fast, likely to cause damage to the plastic layer and the wire break, so that premature failure of the hose in use .The above information is very detailed description of the effect of the size of the amount withheld for the use of high-pressure hose produced , so we need considerable attention when using this withholding his dosage size is accurate, whether the mutation will produce high pressure hose , etc. problems should close attention.