installation and considerations of hydraulic tube fittings

Hydraulic tube fittings installation Notes: moving or still in the pipeline are not excessive bending, can not bend at the roots, moved to the extreme position when the pipeline must not pull too tight, should be more relaxed; try to avoid torsional deformation of the pipe; pipe as far as possible away from heat radiating member, the necessary insulation board fashion. Hydraulic tube fittings  pipeline installation: Hydraulic tube fittings to try to avoid the heat radiation and cooling water temperature is too high or too low spray and other place, conflict occurs when you install, you should make a small tube bassoon, low-pressure hydraulic tube fittings so that the high-pressure pipe; pipe cross each other can not be contact should be separated by a certain distance. In the hydraulic system, both the metal pipe hydraulic tube fittings, hose fitting, or are prone to leakage problems. For card sets of hydraulic tube fitting joints, mostly due to the pipeline by a larger force or impact, so that the card sleeve loose or pipe end surface deformation caused by leaks, you should check whether the card sets out of round, edge or without defects, whether the pipe ends in good condition and the extent of compression ferrule nut, but also eliminate the pipeline force. For flared fittings, mostly due to excessive flaring, substandard quality requirements or repeatedly demolished, resulting in flaring deformation or cracks caused by leaks, then you can be re-flared front amputated.